Roof Pitch Calculator: Plan vs Field Check
A rise of 6 in over a horizontal run of 12 in is 26.57°: arctan(6 ÷ 12) = 26.57°. Do not enter a drawing dimension until it is the same roof plane and horizontal run as the field record.
arctan(6 ÷ 12). Copying a 24 in full span as the run instead gives 14.04°, flattening the recorded angle.
arctan(150 ÷ 300). Copying 300 mm as 3,000 mm gives 2.86°, turning one extra zero into a near-flat record.
arctan(4 ÷ 12). Copying the 4 in rise as 4 ft while keeping a 12 in run gives 75.96°, a unit-label error rather than the same roof result.
How each example is calculated
For every pair, use degrees = arctan(rise ÷ horizontal run) × 180 ÷ π. The unit can be inches or millimetres, but rise and run must use the same unit within that one calculation. The first two correct pairs have the same ratio, 0.5, so both return 26.57°.
| Record | Calculation | Correct angle | What the transcription error changes |
|---|---|---|---|
| 6 in rise; 12 in horizontal run | arctan(6 ÷ 12) | 26.57° | Using a 24 in full span as run returns 14.04° instead. |
| 150 mm rise; 300 mm horizontal run | arctan(150 ÷ 300) | 26.57° | Writing 3,000 mm for run returns 2.86° instead. |
| 4 in rise; 12 in horizontal run | arctan(4 ÷ 12) | 18.43° | Reading the rise as 4 ft (48 in) returns 75.96° instead. |
Check the plan against the field pair
A plan note and a field observation can describe different records even when they are both expressed in the same unit. Before using either one as the calculator run, identify the physical roof plane and the two endpoints of the horizontal baseline. A full building span is not automatically the one-plane run used by a pitch calculation.
Keep the source beside the number
Write the plan dimension as a plan dimension. Write the field observation as vertical rise plus horizontal run. Keep both entries beside their units, plane label, and reference points. That preserves the source of a disagreement instead of hiding it inside a new calculated number.
Can I use a plan dimension as my calculator run?
Yes, only if it is the same intended horizontal run on the same roof plane. If the drawing shows a full span, a scale-only line, or an unnamed baseline, it is not yet interchangeable with a field rise/run record.
Calculate after the record check
Once rise, horizontal run, plane, and units agree, enter the pair in the roof pitch calculator. If two field records still disagree, keep both visible and use the repeat measurement check before deciding which one represents the intended input.